I have a 2003 BMW 325i next to 2 12" Alpine Type R SWR-1242D subwoofers and 2 Kenwood KAC-8103D 1000 watt amps sitting in a ported hutch with a factory guide unit. I'm trying to catch more bass in my coup¨¦ by cutting out the ski hole located astern the center armrest in the stern seats. I own already cut out the foam that is located directly higher than the thin sheet metal plate. There is a small hole which be covered by a tab that I poked out which is now a small port but I know near is more bass to be gotten. I am now trying to cut a bigger hole but looked-for to know how I should go nearly it and what I should use. The hole is much too small to use a metal saw and I was even thinking of going primitive and basically using a mallet and chizzle but I don't want to ruin the car. I know at hand has to be an easier means of access to make a great port for my system. Any clues?
Answers: Enlarge the hole beside a drill bit , big enough to gain a sawsall blade in later cut it with the sawsall!!
More Auto Questions and Answers...
What is the best supercharger for my 2000 4.0l elegant cherokee?
How much is a extra 2007 Nissan altima keyless start knob fob cost.?
Can i elevate the front of my truck 1.5 - 2 contained by. by simply installing contemporary Coil springs?
Whats the stock cam duration and move up for a1978 chevy el camino near a 305ci?
I call for to know the owner of vehicle License plate 4JNZ40 surrounded by Texas?
How do i control my convertible top?
This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.