Answers: Use this electric wiring guide to help you flex your sub. You will get a optical display of how to wire your sub.
http://www.crutchfield.com/learningcente...
Good Luck!
Hook them up surrounded by parallel.
Here's the way it works:
If you lead speakers in series, make a payment the ohms together to get the total resistance. If you cable the speakers in parallel, you use inverted complement, which looks like this:
1 / ((1/a)+(1/b)+(1/c)+...)
where on earth a,b,c, etc are the resitances for each speaker.
Let's speak you have 2 speakers, respectively with 2 4-ohm voice coils. And you are hooking them up to an amp that's bridged down to 1 direct, 1 ohm stable. If you hooked them up in series, you would enjoy the amp + going to one of the coil's +, then respectively - will go to another coil's +, and the concluding - will go fund to the amp's -. I hope that's not too confusing. Anyway, hooking them up this way will be paid it 4+4+4+4 or 16 ohm.
If you hook them up parallel, which is the amp's + to each coil's +, and respectively coil's - to the amp's -, then the resistance will be:
1 / (1/4 + 1/4+ 1/4+ 1/4) or 1/1, which is 1 ohm.
you can use a simplified magazine of the inverted addition, which is to voice, any time you hook up 2 coils with equal resitance contained by parallel, you half the resistance. If you hook them up contained by series, you double the resistance.
If its a single sub it would have to be a dual voice coil 2 ohm sub. If it is after all you do is flex the positive from the amp to BOTH positives then a lead from the negative to BOTH negative. This is called parrallel. If its a 4 ohm sub later all you are going to obtain is a 2 ohm load.
More Auto Questions and Answers...
This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.