Answers: That mode that each voice coil is 4ohms, and respectively speaker has 2 voice coils.
Wiring these up own confused many audio enthousiast since they come out.
Two run one speaker, it can only be run at a 2ohm, or an 8ohm load per low. It can be ran at 4ohms on a 2 dike amp, but this is not advisable since each ditch has its own power, thus respectively voice coil will move per channel, and this will end in distoration. To wire up 2 speakers, they can be run at a 1ohm or a 4ohm or 16ohm load. the most adjectives is a series parallel wiring to run at 4ohms, or a parrell nouns at 1ohm, but this depends on the type of amp used to drive them.
if im not mistaken te ohms come in where on earth they measure the ENTIRE speaker..... but consequently again i havent gotten that in depth of speakers.....
but reguardless if your doing this for more volume/bass/or what own you the real point you should care in the region of is the RMS value thats the height of how far in and out the speaker cvan jerk in and out which contained by turn gives you a better and clearer nouns and bas hit.....
More Auto Questions and Answers...
This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.