Why does my Positive cable on my Suburban burn when I Use my 600W Amplifier?

I had to vary out my starter when I initially installed My Subs and Amp back contained by Nov06. Now a year later I have to change out my +Positive Cable because the alternator wa not getting to the mobile. Plus the junction box melt. Any help would be great!


Answers:    You probably obligation dual batteries, if you don't already hold them.

You're putting too much current through not enough cable to prevent excess heat build-up.

Your amp should own its own power coming off a mobile, through a fuse or circuit breaker.

The wire coming from the alternator to the battery(s) should be at lowest possible a big as the stock on was, beside a good, tight nouns.

You shouldn't take a nurture directly off the alternator forr your nouns system, unless you already have changed it out fo for a super-heavy-duty one that puts out plenty for your system, and own a good power filter between the alternator and your system.
to much power, electricity is hot and thus you are burning your cable near excesive load. buy better cable.
More Auto Questions and Answers...
  • Car cd player does not work?
  • I am thinking roughly buy some subwoofers for my motor. I be wondering what RMS Power Handling is?
  • Another put somebody through the mill for KAEZOO?
  • How is Kenwood surrounded by saloon audio? how is its output as compared to JVC?Which one should i run for?
  • Does anybody know what the speaker wires are for a 98 Jeep pompous cherokee near a factory Infinity amp?
  • Replacing Voice Coil..?
  • This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.


    Copyright 2006-2008 AutoQnA.com All Rights Reserved.