# OUTPUT (watts):RMS @ 4 Ohms 220x2
# RMS @ 2 Ohms 380x2
# RMS @ 4 Ohm Mono 760x1
# T.H.D.: 0.02%
# FREQ. RESPONSE (Hz): 10 - 30k
# SIGNAL TO NOISE RATIO: >97dB
# DAMPING FACTOR: >200
# INPUT SENSITVITY: 0.5 - 4.0V
# CROSOVER SLOPES: 12dB
# CROSSOVER FREQUENCY: High-Pass(Hz) 50 - 600
# Low-Pass(Hz) 50 - 150
# SUBWOFFER EQ: 0 - 18dB 0
# SUBWOOFER EQ FREQ. (Hz) : 40 - 120
# DIMENSIONS (INCHES): 9.5x2.5x20.0
# Fully regulated MOSFET power supplies
# PWM circuitry
# Tri-guard amplifier protection
# IDI (Intelligent Distress Indicator) gives a optical indication of the amplifiers protection status
# Platinum RCA inputs and outputs
# Line Outputs
# Bi-linear selectable crossovers for inputs and outputs (Hi/Full/Low)
# Continuously variable elevated and low-pass crossovers
# Variable subwoofer equalizer
# Phase inversion switch (0 - 180)
# OEM floating ground input
# Platinum 4-gauge power connectors
# Tri-mode operation
# Optional Remote Bass
Answers: That subwoofer is so awesome.
That amp ruins it.
Thats all here is to it.
Go with a Kicker amp, or Alpine.
Other than thatm for that L7 nought else will do.
Soundstream makes top of the file gear, so nice choice.
Wire one coil to each output dike of the amp. The sub will recieve about 760watts RMS. Be smooth on the gain knob and it will power the sub perfectly.
Have Fun!
More Auto Questions and Answers...
This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.