i own no knowleadge AT ALL with stereo systems :(
I basically wanted to kno how?
Answers: First rotten in the paraphernalia you bought there should be three (3) chief wires you are going to need:
RED - Goes connected to the + (positive side) of the battery-operated.
Brown/Blue/Black - This goes connected to the cars frame. This is also specified as ground.
Blue - This is the REM (remote) wire that turns the amp on and past its sell-by date.
First take your POWER chain and run it to your battery but dont connect it. Then run the rest to somewhere you are putting your amp.
Second take the GROUND cable and connect it to the cars frame making sure that adjectives the paint is removed from the contact point. Run that cable to where you are going to locate your amp.
Third thieve the REMOTE wire and locate the REMOTE AMP flex on the back of your radio, most of the time its blue beside a white stripe. Be warned that most of the time here are two blue and white wires, one of them runs the power antenna and the other is the amp remote turn on. If your amp doesnt turn on after all is connected after check to make sure that these wires are not crossed.
Along near your kit within should have be a set of RCA cables, these look resembling wires that run a dvd player. Connect those to the OUTPUT connections on the back of the radio and run those to the amp. These verbs the signal from the radio to the amp.
After doing all that progress back to the front of your motor and put in your in-line fuse. This fuse should be connected no more than six (6) inches from your freestyle to prevent a short of your electrical system. After connecting the fuse block then connect the POWER rope to the battery but do not install the fuse all the same. Next go hindmost to the amp and , if you havent done so already, connect all the wires to their appropriate connections on the amp. They should adjectives be labeled. Next take the speaker telecommunication and wire up your sub to the amp. After this jump ahead and install the fuse in the holder and turn on your radio. Check to gross sure that the amp turns on and off next to your radio, if so then the connections are biddable if not later check your remote wire to put together sure that the wire isnt connected to the wrong place. This is unsophisticatedly the way to cable a single amp set-up. Hope this helps.
look at the directions
More Auto Questions and Answers...
This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.