I was getting into my motor yesterday and tried to start it. But it didn't do anything. I thought that it may have be the steering wheel lock or the gear shift wasn't properly busy in park. I thought that it could own been the push button itself because it has a metal piece on it. I'm not sure. It didn't do anything. Not even crank. I kept inserting and removing the switch and for a while it didn't do anything. It finally started after about an hour and a partially of sitting there messing next to it. What could it be and how easy and expensive would it be to draw from it fixed?
Answers: Your camaro should have GM's Vehicle Anti-Theft System (VATS) which resources your ignition keys hold a resistor embedded surrounded by them. You can try cleaning the key or using another switch. Have a new switch made up at a locksmith that does GM VATS keys. Make sure you hold a good mobile in the motor and replace it with a contemporary one if it's over 4 years old to minimize problems near VATS.
Read the VATS troubleshooting information here:
http://vats.likeabigdog.com/
Try buying a new one
More Auto Questions and Answers...
Why is my 1994 toyota tercel using 3 qts of grease for every 125 miles driven?
Where do i rent a manacle wrench?
How do you winterize a bike?
I only just have the car's front tires suspended but this didn't procure rid of the wave backwards and forwards contained by the steering gearstick.
How do you remove the bottom bolt of the front calipers on a 1997 lexus Ls400?
I've basically brought 4 trial tyres for my sports car but very soon if you permit walk of the gearstick, it drifts to the disappeared, why?
This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.