Answers: You will stipulation special tools. Remove the serpentine belt. remove the nut from the compressor shaft holding the clutch with a spanner wrench. Remove the clutch near the clutch remover tool. Remove the snap ring that holds the pulley and slide off the pulley. to re assemble the clutch you will also necessitate the clutch installer tool. and the gap should be in the region of .080 inch when you are done.
Need a AC clutch hub remover tool,screw onto the hub,push it out.
borrow a puller from autozone, it's free, they give you rear legs a deposit when you bring it back, it screw into the front of the pulley and then you tighten the center bolt of the puller, a strap wrench works honourable to keep the clutch from turning, but in general it's not a problem.
their is a puller(special tool)it screws into the clutch and have a bolt that pulls off the clutch.
It is usually done by a pro. But that is to say up to you.
More Auto Questions and Answers...
This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.