Need Chevy Truck Help?

Have a 1988 Chevy Silverado 4X4 That I found a rear winding up for. The old U-Bolts are gone and I own no clue what size they were to take the new ones, adjectives help would be appreciated! It have a 5.7 engine and a 3.42 rear completion. Thanks


Answers:    www.partsamerica.com they"ll have what ya obligation....
PS they"re 6 inches long X 3/4 with a 3inch arc.... within some cases i have found a few next to metric bolts too.


PSS If your looking for a good spot for replacement parts try www.lmctruck.com/chevy these guys are the best for body pannels.
Try this guy............

www.texaserick.com
Look contained by the yellow page for a suspension and "spring" shop that specializes in branch and coil spring work on cars and trucks. You may get the unsullied U bolts with some suspension component purchases through SkyJacker or Rancho suspension parts and their websites and tech info could bring up to date you what size and thread U bolts you need.
http://www.skyjacker.com/
http://www.infospace.com
bring your rear appendage in to place and put the bottom plate against the housing. use a rope turn over the housing and through the plate .measure it up and you should be indisputable close. make it long and you can cut the over hang up off.
More Auto Questions and Answers...
  • When I turn my wheel adjectives the track to the right or gone and hit the gas I hear squeaking.?
  • If I did the upholding prompt as recommended by the production how long will my coup¨¦ engine finishing ??
  • Antifreeze discharge?
  • Need abet near my motor.?
  • I hear a knock din surrounded by my engine and my grease pressure is low, any design?
  • Holden WB kingswood, bonnet release lever will not enlarge (release) the hood. Any thinking? - Without cutting/force

    • This article contents is post by this website user, AutoQnA.com doesn't promise its accuracy.


    Copyright 2006-2008 AutoQnA.com All Rights Reserved.